informatica:linux:comprobar_velocidad_tarjeta_red
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
informatica:linux:comprobar_velocidad_tarjeta_red [2009/03/13 09:38] – 194.179.83.89 | informatica:linux:comprobar_velocidad_tarjeta_red [2009/03/13 09:39] – borrado 194.179.83.89 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | red ethernet eth interfaces velocidad | ||
- | |||
- | **ANTECEDENTES** | ||
- | |||
- | Tenemos una tarjeta de red, y queremos saber si soporta velocidades de 10000mbps (' | ||
- | |||
- | **SOLUCIÓN** | ||
- | |||
- | (Como root) | ||
- | |||
- | 1. Suponiendo que la tarjeta de red sea ' | ||
- | |||
- | dmesg | grep eth0 | ||
- | [ 1.990066] e1000: eth0: e1000_probe: | ||
- | [ 536.704969] e1000: eth0: e1000_watchdog: | ||
- | [ 758.407797] eth0: no IPv6 routers present | ||
- | |||
- | En este caso va a 10mbps = mojón | ||
- | |||
- | Mejor instalar ethtool que te dice todo lo que soporta y a cuanto está ahora: | ||
- | #apt-get install ethtool | ||
- | |||
- | # ethtool eth0 | ||
- | Settings for eth0: | ||
- | Supported ports: [ MII ] | ||
- | Supported link modes: | ||
- | 100baseT/ | ||
- | 1000baseT/ | ||
- | Supports auto-negotiation: | ||
- | Advertised link modes: | ||
- | 100baseT/ | ||
- | 1000baseT/ | ||
- | Advertised auto-negotiation: | ||
- | Speed: 100Mb/s | ||
- | Duplex: Full | ||
- | Port: MII | ||
- | PHYAD: 0 | ||
- | Transceiver: | ||
- | Auto-negotiation: | ||
- | Supports Wake-on: g | ||
- | Wake-on: d | ||
- | Link detected: yes | ||
informatica/linux/comprobar_velocidad_tarjeta_red.txt · Last modified: 2015/04/13 20:19 by 127.0.0.1