Differences

This shows you the differences between two versions of the page.

--- informatica:linux:vagrant [2020/05/15 14:50] – javi
+++ informatica:linux:vagrant [2020/05/15 14:53] – javi
@@ Line 196: / Line 196: @@
   sudo ip link set virbr1 down
   sudo brctl delbr virbr1
+===== Cambiar rango IPs de libvirt =====
+  /etc/libvirt/qemu/networks/vagrant-libvirt.xml
+        before
+<code>
+<network ipv6='yes'>
+  <name>vagrant-libvirt</name>
+  <uuid>f9dd4e87-b07e-4722-a8a4-bd2b7bcd8aa5</uuid>
+  <forward mode='nat'/>
+  <bridge name='virbr1' stp='on' delay='0'/>
+  <mac address='52:54:00:41:40:ca'/>
+  <ip address='192.168.121.1' netmask='255.255.255.0'>
+    <dhcp>
+      <range start='192.168.121.1' end='192.168.121.254'/>
+    </dhcp>
+  </ip>
+</network>
+</code>
+  sudo virsh net-edit vagrant-libvirt
+<code>
+<network ipv6='yes'>
+  <name>vagrant-libvirt</name>
+  <uuid>f9dd4e87-b07e-4722-a8a4-bd2b7bcd8aa5</uuid>
+  <forward mode='nat'/>
+  <bridge name='virbr1' stp='on' delay='0'/>
+  <mac address='52:54:00:41:40:ca'/>
+  <ip address='10.151.0.1' netmask='255.255.255.0'>
+    <dhcp>
+      <range start='10.151.0.1' end='10.151.0.254'/>
+    </dhcp>
+  </ip>
+</network>
+</code>
+  sudo service libvirtd stop
+  sudo ifconfig virbr1 down
+  sudo ip link set virbr1 down
+  sudo brctl delbr virbr1
+  sudo service libvirtd start
+Bridge was NOT created...
+Solution: start the network
+  sudo virsh net-start vagrant-libvirt
 ===== Errores =====
@@ Line 341: / Line 394: @@
   vagrant up
-====== Cambiar rango IPs de libvirt ======
-  /etc/libvirt/qemu/networks/vagrant-libvirt.xml
-        before
-<code>
-<network ipv6='yes'>
-  <name>vagrant-libvirt</name>
-  <uuid>f9dd4e87-b07e-4722-a8a4-bd2b7bcd8aa5</uuid>
-  <forward mode='nat'/>
-  <bridge name='virbr1' stp='on' delay='0'/>
-  <mac address='52:54:00:41:40:ca'/>
-  <ip address='192.168.121.1' netmask='255.255.255.0'>
-    <dhcp>
-      <range start='192.168.121.1' end='192.168.121.254'/>
-    </dhcp>
-  </ip>
-</network>
-</code>
-  sudo virsh net-edit vagrant-libvirt
-<code>
-<network ipv6='yes'>
-  <name>vagrant-libvirt</name>
-  <uuid>f9dd4e87-b07e-4722-a8a4-bd2b7bcd8aa5</uuid>
-  <forward mode='nat'/>
-  <bridge name='virbr1' stp='on' delay='0'/>
-  <mac address='52:54:00:41:40:ca'/>
-  <ip address='10.151.0.1' netmask='255.255.255.0'>
-    <dhcp>
-      <range start='10.151.0.1' end='10.151.0.254'/>
-    </dhcp>
-  </ip>
-</network>
-</code>
-  sudo service libvirtd stop
-  sudo ifconfig virbr1 down
-  sudo ip link set virbr1 down
-  sudo brctl delbr virbr1
-  sudo service libvirtd start
-Bridge was NOT created...
-Solution: start the network
-  sudo virsh net-start vagrant-libvirt